• Make a good investment
  • Reduce your electricity bills
  • Sell electricity back to the grid
  • Be energy efficient
  • Cut your carbon footprint
  • Be clean and green


myenergi products available from PDP Services

PDP Services is a myenergi Approved Installer. 

This clever little piece of kit helps you to self-consume the green energy produced by your microgeneration system. The eddi device acts as an automatic power controller that diverts surplus power to a designated area – normally a hot water heater, to save energy and minimise your utility bills.

The eddi system is fitted with a clear, graphical LCD display that will detail your saving information.

It works as stand alone product with size array to heat your immersion heater, storage heater, under floor heating, towel rail or electric radiator. The eddi does this with surplus power from your solar panels or wind turbine.

This controller really is the perfect addition to any PV or wind turbine installation. Click here for the eddi datasheet.


myenergi’s intelligent electric vehicle charger is the first of its kind. This smart device enables you to charge your electric car with surplus energy.

It has 3 charge modes, the cleverest being our ECO & ECO+ modes, which maximise the effectiveness of your microgeneration system. You can charge your car with surplus energy, enjoy a full graphic display and view listings of your savings from date of installation. zappi can also sense when economy/cheaper tariff’s are available ensuring you get the cheapest charge possible.

If you don’t yet have solar panels or a wind turbine, zappi will still benefit you in lots of ways. Whichever charge mode used, zappi will dynamically alter the charge rate as and when appliances are turned on and off in the home, ideal if there are any electrical supply restrictions. The eco-smart functionality of zappi will start saving you money from the very first charge. Click here for the zappi datasheet.


harvi is a clever little device that enables the zappi and eddi products to be installed without using a wired current transformer (CT) for measuring the grid and or generation power; instead the CT is connected to harvi. No power source is needed for harvi – the energy from the CT is harvested and used to transmit the measurement signal to the zappi or eddi. This means batteries or electrical wiring are eliminated! Click here for more information.


myenergi created libbi to store your electricity, to use it when you need it most. It allows you to capture as much surplus solar electricity as possible, whilst integrating with your existing myenergi devices.

libbi is modular by design. Each module can store up to 5kWh of electricity, so combining 4 of them together would provide up to 20kWh of storage.

libbi isn’t just a battery storage system, it’s eco smart. This means it makes intelligent decisions about when it provides and stores electricity based on how much energy you use, how much you generate with your solar and the electricity tariff you use.

libbi seamlessly connects to your existing myenergi devices. This allows it to make intelligent decisions about when to charge or drain your battery based on your usage, your tariff and your self generated electricity. It performs 5 core functions: solar charging; grid charging; advanced control; blackout backup; anti-draining

To see how all three products work together click here to see the myenergi system overview.

For more information call 01444 480444 to speak to one of our renewable energy specialists or email info@pdp.services.